Product
Description
3-Part, 100% Solids, Trowellable Epoxy Flooring System Consisting of:
Part A – Resin
Part B – Hardener
Part C – Blended
Granite,
plus Tint
- Self-Priming, Resin-Rich
- No Sealer Topcoat Needed
- U.S.D.A. Approved
- Low Odor/Solvent Free
- V.O.C. Compliant
- Blended Mix for Coves
- Dense Compact Finish
- Hygienic, Easy to Clean Surface
- Resin Rich Surface Helps to
Resist Bacterial Growth
Special Features
- Meets ASTM C-884
- Thermal Compatibility
with Concrete
- Excellent Adhesion to Clean,
Sound, Damp Concrete
- Excellent Adhesion to fresh
Concrete by Priming with
Corro-Cure
- Resistant to Many Acids,
Solvents and Cleaning Solutions.
(Refer to Chemical Resistance
Chart)
- Built in Resiliency for Thermal
Shock (Steam Cleaning) and
Impact Resistance
- Can be Used Indoors or
Outdoors
- User Friendly Mix Ratios
- Power Trowellable
- Water Wipeable
|
Application
- Monolithic Floor for Heavy Traffic
- Repairing of Highly Eroded
Concrete Floors
- Where Good Chemical Resistance
is Required
- Excellent Abrasion Resistance
- Textured Finish
- Excellent for C.I.P. Areas
Priming
Corro-Flor is resin-rich and does not need a primer on
sound concrete. For deteriorated concrete, priming will help reduce
outgassing, blistering, and dry spots. Refer to Corro-Prime data sheet. If
the Corro-Flor is going to be applied over "green" concrete,
then our Corro-Cure (a slow set primer) must be used first. (Refer to
Corro-Cure data sheet.)
Packaging
Corro-Flor is available in the following pak sizes:
Standard Pak - Pre-measured
4 Gallon Pak – 25 SF @
¼"
Ten Pak - Pre-measured
10 x 4 Gallon Paks – 250 SF @ ¼"
48 Bulk Pak - 192 Gallons in Bulk –
1200 SF @ ¼"
Drum Pak - 532 Gallons in Bulk –
3325 SF @ ¼"
Coverage will vary depending on surface texture.
Set Times
Corro-Flor is available in various setting times.
Corro-Flor
Corro-Flor F.S. (Fast Set)
Corro-Flor X.F.S. (Extra Fast Set)
Corro-Flor C.S. (Cold Set)
Corro-Flor X.C.S. (Extra Cold Set)
Applications below 35° F please consult
the factory.
|
